VELOCITY ADJUSTMENT INCREASE/DECREASE
To increase your velocity FPS (Feet per second) using the allen wrench turn the Velocity Adjuster (#296) clockwise.
To decrease your velocity FPS (Feet per second) using the allen wrench turn the Velocity Adjuster (#296) counterclockwise.
NOTE: Velocity Adjuster w/Spring Guide (#296) doesn’t remove from the rear of the Striker Plug (#260).
- The recommended Velocity speed should be no greater then 300fps. Not doing so can cause serious injury if the velocity is dangerously high.
- Spyder MR3 paintball markers are not intended to shoot any person less then 25 feet.
- Never point a loaded Spyder MR3 paintball marker at any person who is not wearing the proper face protection.
- Never at any time should you look down the barrel when the marker is loaded or not.
- Using a paintball marker outside a non designated paintball field can be illegal, and is subject to law enforcement penalties if property damage is caused by the user.
SPYDER MR3 PAINTBALL MARKER SHOULDER STOCK INSTALLATION
Place the Shoulder Stock (#332) on the back end upper section of the Receiver (#325). Once the Shoulder Stock is in place tighten the Set Screw (#16) to secure the stock to the body of the marker.
The Set Screw (#16) is located on the right side of the receiver.
ADJUSTING SHOULDER STOCK LENGTH
Turning the Shoulder Stock Screw (#333) counter-clockwise will loosen the Shoulder Stock allowing for three different lengths to be achieved.
Spyder MR3 Manual
Spyder MR3 Paintball Gun and Compressed Air Tank
Spyder MR3 Paintball Gun Electronics and Settings
Spyder MR3 Paintball Guns Battery Charging
Spyder MR3 Disassemble Reassemble and Cleaning Internals
Spyder MR3 T-Cocking Removal
Spyder MR3 Anti Chop Eyes
Spyder MR3 Cup Seal Removal
Spyder MR3 Paintball Gun Schematics
How to get free paintball stuff. You have to know about free Target $500 gift card.
