1. The D.L.P has one push key for adjustment and one LED Array for Mode Indicator, and two digits LED to display ROF.
2. For "MODE" indicator, the LED Indicator shows following functions: ( From left hand side to right hand side, the left hand side is the side near push key. )
(1). Battery Low
(2). SEMI
(3). Burst-3
(4). Burst-6
(5). FULL
3. For "R.O.F." display , the rate of fire can be adjusted from "05" to "13", that is the rate of fire will be ranged from 5 shots per second to 13 shots per second. But for "SEMI" mode, the "R.O.F" display will be fixed on "13" for reactive trigger response up to 13 shots per second.
4. When Power turns ON, the defaults will be Mode ="SEMI" and "R.O.F" = "13". All settings can be adjusted while power keeps ON. Any adjustments will be lost when Power turns OFF.
5. The "Battery Low" Indicator will keeps OFF during normal operations. When the capacity of battery dropped to about 1/3 of the battery full capacity, this indicator will be turn ON.
6. The D.L.P also equipped with a "LOCK" function. A short-circuit plug located on the internal circuit board serves this function. When this plug had been pulled out, the MODE will be locked to SEMI, and cannot be adjusted.
7. Operation Methods:
Press, Push and hold the key for over 2 seconds, then release the key.
Click, Push and then release the key. The duration should be less than 1 seconds.
It is recommended that the battery be charged prior to use to ensure the maximum capacity if you leave the battery unused for over a week.
LIFE OF BATTERY
With the qualified Charger, and in normal use conditions, about 700 – 1000 chargerecharge cycles can be expected. This be varied depending on the type of use.
GENERAL MAINTENANCE
- Use compressed air to clean the coil set after each use (part no. #JE18C) to maintain performance.
- Beside step (1), cleaning should only be performed on the exterior of the E-Marker frame. Never submerge the E-Marker frame in any type of liquid for any reason. The electronics may become damaged or destroyed. Keep water or cleaning solution from entering the inside of the E-Marker frame. Solvents should not be used to clean any part of the E-Marker frame.
- Always use the appropriate tool to remove screws and other components of the EMarker frame.
- DO NOT DRY FIRE.
Spyder Electra DX Tournament Mode Setting
The Spyder Electra DX paintball marker circuit board – (Digital LED) part no. E29E also equipped with a "LOCK" function. A short-circuit plug (JE30B) located on the internal circuit board serves this function. When this plug had been pulled out, the MODE will be locked to SEMI, (single shot mode) and cannot be adjusted. Putting the lock switch (JE30B) back into the circuit board will enable the multi-mode functions. IMPORTANT! For optimal performance, Kingman recommends that an agitator loader or hopper be used in order to shoot at high rate of fire. Kingman also recommends to use JAVA CO2 Air Tank or High Pressure Air Tank and tournament grade paint.
Spyder Electra DX Users Manual
Spyder Electra and Electra DX Parts List
Spyder Electra Charging Instruction and Specifications
Spyder Electra DX Recharging the Battery After Initial Use
Spyder Electra DX Troubleshooting
How to get free paintball stuff. You have to know about free Target $500 gift card.
